Getting Ready
Configuring Initial Control Box Settings
After you finish configuring the initial settings of the two projectors, perform the procedure below to configure initial Control Box settings.
Perform the operations below using the Control Box remote controller
To configure initial Control Box settings
1.Press the remote controller [ALL] key (or [1] key) to turn on Control Box power.
zThis also turns on the two projectors linked to the Control Box.
2.On the remote controller, press the [MENU] key to display the setup menu.
zUnder initial default settings, menus are displayed in English.
3.Select “Option Settings” and then “Language”, and then use the [U] and [I] keys to select the language you want.
4.Configure the settings below as required. For details about each setting, refer to the
zOption Settings 3 Eco Mode
zImage Properties 3 Color Mode
zOption Settings 3 Remote Power Numbers
5.Next, perform the procedure under “Adjusting the Positions of the Two Projectors” (page
Control Box Power On/Off
The Control Box remote controller has five power keys. Four of them are numbered from [1] to [4], and the fifth one is marked [ALL]. This allows power on/off control of multiple Control Boxes in the same location.
zPressing the [ALL] key turns on all of the Control Boxes.
zKeys [1] through [4] control the Control Boxes that are assigned the corresponding number with the “Option Settings 3 Remote Power Numbers” setting.