Getting Ready

5.Perform the steps below to adjust the position and size of the Projector B image so it slightly runs off the edges of the target screen, as shown in the “After adjustment” image above.

(1)Adjust the zoom ring of Projector B.

(2)Loosen the five screws that secure the cabinet side panels, and then rotate the adjuster knob to adjust the orientation.

zTake care simply to loosen the five screws. Do not remove them.

Fixing screws

Adjuster knob

Fixing screws

zAfter adjusting the position, re-tighten the fixing screws. Note that you will need to make fine adjustments later in this procedure, so do not fully tighten the fixing screws at this point.

6.With both the Projector A and Projector B images being projected, repeat steps 3 and 5 as required to minimize the difference between the shape of the Projector A and Projector B images.

Adjustment 2: Fine adjustment using the adjustment pattern

3

Before adjustment

After adjustment

7.On the Control Box remote controller, press the [CORRECT] key.

E-12