Getting Ready

Wiring

Wire the Control Box and two projectors inside the Cabinet as shown in the illustration below.

Projector A

(Side nearest the Control Box)

Ferrite core

Control Box side

Use a supplied RS-232C cable to connect.

Use a supplied HDMI cable to connect.

Use the supplied power cord to plug into an outlet.

Projector B

(Side furthest from the Control Box)

When connecting the Control Box to a projector using a supplied HDMI cable, connect the plug of the cable that is nearest the ferrite core to the HDMI port of the Control Box.

Control Box back

*1

Connect the supplied AC adapter and plug it into a power outlet.

Use a commercially available HDMI cable to connect to the HDMI output port of an image source device.

*2

Connect to the RGB output terminal (using the included D-sub mini cable or a commercially available cable) or the component output terminal (using a commercially available cable) of the image source device.

*1 To control the Projector System from an external device over a LAN, use a commercially available LAN cable to connect this terminal to the LAN terminal of the external device.

*2 To control the Projector System from an external device over an RS-232C connection, use a commercially available serial cable (cross) to connect this port to the serial port of the external device.

NOTE

zThe HDMI cables and RS-232C cables that connect the Control Box to the projectors can be stored in Storage Box (A) when they are unneeded. The Control Box AC adapter can be stored in Storage Box

(B). See page E-15of this manual for an illustration that shows the locations of Storage Box (A) and Storage Box (B).

E-7