Getting Ready
Adjusting the Positions of the Two Projectors
Use the procedure in this section to adjust the projected images of the two projectors so they are approximately the same size and at the same position on the target screen (the screen, wall, or other surface to be used as the projection surface after setup of the Projector System is complete).
zAfter you finish configuring the initial settings of the Control Box, perform the procedure below.
zFor information about which projector is Projector A and which one is Projector B, see “Wiring” (page
Perform the operations below using the Control Box remote controller
To adjust the positions of the two projectors
1.If you shut off power after finishing the procedure under “To configure initial Control Box settings” (page
Adjustment 1: Rough alignment of the two projection screens
Projector A image
|
|
|
| 3 |
| Target screen |
| Target screen |
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Projector B image |
|
|
| ||
| Before adjustment |
|
| After adjustment | ||
2.Attach the lens cover to the lens of Projector B only so only the Projector A image is being projected on the projection screen.
3.Perform the steps below to adjust the position and size of the Projector A image so it slightly runs off the edges of the target screen, as shown in the “After adjustment” image above.
(1)Move the cabinet to change its orientation.
(2)Adjust the zoom ring of Projector A.
4.Remove the lens cover from the lens of Projector B so its image is projected.