Getting Ready
8.On the “Image Shaping” menu that appears, select “Adjust Image Position” and
then press the [ENTER] key.
zThis will project two adjustment patterns, a yellow one for Projector A and a light blue one for Projector B.
zUse the focus rings of Projector A and Projector B to adjust the focus of the patterns as required.
Important!
zAll of the explanations in this manual assume that Projector A is connected by HDMI cable to OUTPUT A of the Control Box and that Projector B is connected to OUTPUT B, as shown under “Wiring” (page
9.Observe the adjustment patterns as you adjust Projector A and then Projector B.
Try to achieve the characteristics described below as you make adjustments.
zAdjust so the horizontal crosshairs of the adjustment patterns are horizontal.
zAdjust so the vertical lines of the adjustment pattern crosshairs are in the center of the screen. Projector A : Use the same procedure as that in step 3 to fine tune the adjustment of the
Projector A adjustment pattern.
Projector B : Use the same procedure as that in step 5 to fine tune the adjustment of the Projector B adjustment pattern.
10.On the Control Box remote controller, press the [BLANK] key.
zThis will cause the Projector B adjustment pattern to disappear, leaving only the Projector A adjustment pattern (yellow).
11.While observing the Projector A adjustment pattern, perform the vertical adjustments described below.
zAdjust the vertical orientation of the cabinet.
zAdjust the zoom ring of Projector A.
The crosshairs of the adjustment pattern should be in the center of the target screen and the outer border of the adjustment pattern should be just outside of target projection area, as shown in the nearby figure.
12.Press the remote controller’s [BLANK] key.
zThis will project from Projector B again so the adjustment patterns of both Projector A and Projector B are being projected.
13.Perform the steps below to get the adjustment pattern of Projector B as closely aligned as possible with the Projector A adjustment pattern.
(1)Adjust the zoom ring of Projector B.
(2)Loosen the five screws that secure the cabinet side panels (see the illustration under step 5, above), and then rotate the adjuster knob to adjust the orientation.
zTake care simply to loosen the five screws. Do not remove them.
(3) After position adjustment is complete, fully tighten the screws.
14.After the adjustment is the way you want, press the [ESC] key.
zThis will cause the Projector A and Projector B adjustment patterns to disappear, and project the “Image Shaping” menu.