Getting Ready

Preparing the Remote Controllers

Load two AAA-size alkaline batteries into each of the remote controllers: one YT-200 Control Box remote controller, one YT-120 projector remote controller. Batteries are provided with the Projector System. To load batteries: Open the battery cover on the back of a remote controller. Load the batteries making sure their poles (+/–) are facing in the correct directions. Finally, replace the battery cover.

Important!

zTo avoid running down the battery, store the remote control unit so its keys are not pressed inadvertently.

zWhen batteries go dead, remove them as soon as possible and replace them with two new AAA-size alkaline batteries.

Configuring the Initial Settings of the Two Projectors

The initial settings of each projector need to be configured individually.

zPerform the procedure below after placing the Projector System in the location where it will be used, after connecting cables, and after preparing the remote controllers.

zFor information about which projector is Projector A and which one is Projector B, see “Wiring” (page E-7).

Perform the operations below using the projector remote controller (YT-120). Note that these operations cannot be performed using the Control Box remote controller (YT-200).

To configuring the initial settings of the two projectors

1.Unplug the power cord of Projector B from the power outlet so only Projector A is plugged in.

2.Remove the Projector A lens cover.

3.On the remote controller, press the [P] (Power) key to turn on Projector A.

4.After projection starts, use the Projector A focus ring to focus the projected image.

5.On the “Language” screen that appears, select the display language you want to use.

6.On the remote controller, press the [INPUT] key. On the “Input” dialog box that appears, select “HDMI” and then press the [ENTER] key.

E-8