CBC CTR-030NC-2 manual Power Cord, Audio IN/OUT Jack, Video IN/OUT Jack Reset Button

CONTROL NAMES AND LOCATIONS (cont’d)

REAR

1				2	3
1	ALARM IN				VIDEO IN
2	ALARM OUT			AUDIO IN
3	ALARM RESET
4	GND
5	SERIES IN
6	SERIES OUT
7	WARNING OUT
8	TRIGGER OUT
9	GND
10	LOW TAPE OUT	1 2 3 4	5 6 7 8 9 10 11 12	AUDIO OUT
11	1 SHOT REC IN
12	GND
	RESET
					VIDEO OUT
	4		5

PREPARATION

1.POWER CORD

Connect only to an AC 100-240V, 50/60Hz outlet.

2.AUDIO IN/OUT JACK

Connect the audio input and output terminal.

3.VIDEO IN/OUT JACK

4.RESET BUTTON

Use this button to reset the VCR.

5.12-PIN TERMINAL BLOCK Connect external signals.

Connect the video input and output terminal.

Terminal Signal Levels

TERMINAL			SIGNAL LEVEL		IN/OUT
1. ALARM IN	VIH		VIL	VIH: 4~5V, VIL: 0~0.6V	INPUT
		T		T: above 250msec
2. ALARM OUT	VOH		VOL	VOH: 4~5V, VOL: 0~0.6V	OUTPUT
		T		T: ALARM REC STATE
3. ALARM RESET					INPUT
	VIH		VIL	VIH: 4~5V, VIL: 0~0.6V
		T		T: above 250msec
5. SERIES IN				VIH: 4~5V, VIL: 0~0.6V	INPUT
	VIH		VIL
		T		T: above 250msec
6. SERIES OUT					OUTPUT
	VOH		VOL	VOH: 4~5V, VOL: 0~0.6V
		T		T: above 250msec
7. WARNING OUT					OUTPUT
	VOH		VOL	VOH: 4~5V, VOL: 0~0.6V
		T		T: until any key is pressed
8. TRIGGER OUT					OUTPUT
	VOH		VOL	VOH: 4~5V, VOL: 0~0.6V
		T		T: above 8~10msec
10. LOW TAPE OUT					OUTPUT
	VOH		VOL	VOH: 4~5V, VOL: 0~0.6V
		T		T: below 5 min, end of tape
11. 1-SHOT REC IN	VIH		VIL	VIH: 4~5V, VIL: 0~0.6V	INPUT
		T		T: above 250msec
4, 9, 12. GND		–		0V	COMMON

5