Chamberlain 1215EM FS2 Assemble the Rail and, Attach the Chain Pulley Bracket, For Sliding and Swinging Gates ONLY

ASSEMBLY STEP 1

For Sliding and Swinging Gates ONLYAssemble the Rail andAttach the Chain Pulley Bracket

To avoid installation difficulties, do not run the garage door opener until instructed to do so.

1. Place the 3 rail sections on a flat surface for assembly. The end sections are

identical. Make sure the “arrow label” on the center section is pointing in the direction shown in the illustration.

2.Connect the center section and the 1/4"

lock nuts to the end sections from the same side, as shown.

NOTE: If rail is not assembled exactly as shown, trolley will not travel smoothly along length of rail or it will hit against nuts.

3.Insert the carriage bolts from the opposite side of the end sections. Tighten the nuts. When assembled, rail has a front-to-back position as shown.

4.Position the chain pulley bracket on the front end of the rail as shown. Fasten securely with the hardware provided.

NOTE: When tightening the bolts be sure to keep bracket parallel to the rail. Otherwise, the rail may bow when the opener is operated.

HARDWARE SHOWN ACTUAL SIZE

Carriage Bolts

Lock Nut 1/4"-20x1/2"1/4"-20

Hex Bolt	Nut	Lock Washer
5/16"-18x7/8"	5/16"-18	5/16"

11 mm Socket Wrench

Chain pulley bracket attaches to this end of Rail

1/4'' Lock Nut	Rail
	(End Section)

Brace

AWAY FROM

OPENER

Carriage Bolt 1/4"-20x1/2"

DOOR GARAGE TO

Rail

(Center Section)

Brace

Rail	Hex Bolts
(End Section)
	5/16"-18x7/8"

Square Carriage

Bolt Holes

Rail connects to opener at this end.

			Be	Aligned
		Must
				El sostÈn de la polea
	Rail			del cable se fija a este
	&			extremo del riel.Chain Pulley
	Bracket				Bracket
Rail
	Tuerca de 1/4"			Riel	Lock Washer
				(SecciÛn Extrema)
					5/16"
			Nut
			5/16"

13 mm Socket Wrench

10