Chamberlain 1215EM FS2 OPERATION, The opener lights, When the opener is activated, Using Your Garage Door Opener, Activate your opener with any of the following:

OPERATION

IMPORTANT SAFETY INSTRUCTIONS

WARNING

To reduce the risk of SEVERE INJURY or DEATH:

1.	READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS.	9. If one control (force or travel limits) is adjusted, the other
2.	ALWAYS keep remote controls out of reach of children.		control may also need adjustment.
	NEVER permit children to operate or play with garage door	10.	After ANY adjustments are made, the safety reversal system
	control push buttons or remote controls.		MUST be tested.
3.	ONLY activate garage door when it can be seen clearly, it is	11.	Safety reversal system MUST be tested every month.
	properly adjusted, and there are no obstructions to door		Garage door MUST reverse on contact with 38 mm obstacle
	travel.		on the floor.
4.	ALWAYS keep garage door in sight until completely closed.	12.	ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED
	NO ONE SHOULD CROSS THE PATH OF THE MOVING		(see page 3). An improperly balanced door may not reverse
	DOOR.		when required and could result in SEVERE INJURY or
5.	NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY		DEATH.
	OPEN DOOR.	13.	ALL repairs to cables, spring assemblies and other
6.	If possible, use emergency release handle to disengage		hardware, ALL of which are under EXTREME tension, MUST
	trolley ONLY when garage door is CLOSED. Weak or broken		be made by a trained door systems technician.
	springs or unbalanced door could result in an open door	14.	ALWAYS disconnect electric power to garage door opener
	falling rapidly and/or unexpectedly.		BEFORE making ANY repairs or removing covers.
7.	NEVER use emergency release handle unless garage	15.	SAVE THESE INSTRUCTIONS.
	doorway is clear of persons and obstructions.	15.	SAVE THESE INSTRUCTIONS.
	doorway is clear of persons and obstructions.

8.NEVER use handle to pull garage door open or closed. If rope knot becomes untied, you could fall.

Using Your Garage Door Opener		7. The optional Protector System® uses an invisible beam,
Your Security✚® opener and hand-held remote control		which, when broken by an obstruction, causes a closing
Your Security✚® opener and hand-held remote control		door to open and prevents an open door from closing. It
have been factory-set to a matching code which changes		is STRONGLY RECOMMENDED for homeowners with
with each use, randomly accessing over 100 billion new		young children.
codes. Your opener will operate with up to fifty-four		The opener lights will turn on under the following
Security✚® remote controls and one Security✚® Keyless		The opener lights will turn on under the following
Security✚® remote controls and one Security✚® Keyless		conditions: when the opener is initially plugged in; when
Entry System. If you purchase a new remote, or if you		conditions: when the opener is initially plugged in; when
Entry System. If you purchase a new remote, or if you		power is restored after interruption; when the opener is
wish to deactivate any remote, follow the instructions in		power is restored after interruption; when the opener is
wish to deactivate any remote, follow the instructions in		activated.
the Programming section.		activated.
the Programming section.		They will turn off automatically after 4-1/2 minutes or
Activate your opener with any of the following:		They will turn off automatically after 4-1/2 minutes or
Activate your opener with any of the following:		provide constant light when the Light feature on the
•	The hand-held Remote Control: Hold the push button	provide constant light when the Light feature on the
•	The hand-held Remote Control: Hold the push button	Multi-Function Door Control is activated. Bulb size is A19.
	down until the door starts to move.	Bulb power is 100 watts maximum.
•	The wall-mounted Door Control: Hold the push button or	Timer to close feature (ONLY available when optional
	bar down until the door starts to move.	Protector System® is installed): The door can be
•	The Keyless Entry (See Accessories): If provided with	programmed to close the door automatically in 10
	your garage door opener, it must be programmed before	seconds, 45 seconds, 2 minutes or 3 minutes.
	use. See Programming.	The Timer to close feature is preset to the off position from
When the opener is activated		the factory. To activate this feature, press and hold the
1. If open, the door will close. If closed, it will open.		Lock button on the Multi-Function Door Control until the
2. If closing, the door will reverse.		opener light blinks once (about 10 seconds). A single blink
3. If opening, the door will stop.		indicates that the timer is reset to 10 seconds. Repeat the
3. If opening, the door will stop.

	4. If the door has been stopped in a partially open position,	procedure and the light will blink twice, resetting the timer
		to 45 seconds. Repeat again for a 2 minute interval, etc.,
	it will close.
		up to a maximum of four blinks and 3 minutes.
	5. If obstructed while closing, the door will reverse.
		To deactivate, set the timer to 3 minutes. Press and hold
	6. If obstructed while opening, the door will stop.
		the Lock button on the Multi-Function Door Control again

		for 10 seconds. The opener light will blink 5 times. This
		feature is now deactivated.