PROGRAMMING

NOTICE: If this Security✚® garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional Security✚® remote controls.

To Add or Reprogram a Hand-held Remote Control
USING THE LIGHTED DOOR CONTROLUSING THE MULTI-FUNCTION DOOR CONTROL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

"A" Button

LOCK

LIGHT

"B" Button

1.Remove the cover from the Lighted Door Control.

2.Press and hold the button on the hand- held remote* that you wish to operate your garage door.

3.While holding the remote button, press and hold the “A” button on the Lighted Door Control.

4.Continue holding both buttons while you press the “B” button on the Lighted Door Control (all three buttons are held).

5.Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

"A"

Button

"B" Button

1.Press and hold the button on the hand- held remote* that you wish to operate your garage door.

2.While holding the remote button, press and hold the LIGHT button on the Multi- Function Door Control.

3.Continue holding both buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held).

4.Release buttons when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard.

LOCK

LIGHT

LOCK

LIGHT

To Erase All Codes From Motor UnitMemory

To deactivate any unwanted remote, first erase all codes:

Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All

previous codes are now erased.

Reprogram each remote or keyless entry you wish to use.

*3-Button Remote Controls

If provided with your

garage door opener, the large button is factory programmed to operate it.

Additional buttons on any Security✚® 3-Button remote or mini-remote can be programmed to operate

other Security✚® garage door openers.

36