Manuals / Char-Broil / Kitchen Appliance / Convection Oven

Char-Broil 463269411 Note Make Sure That The Front Brace Is Mounted As Illustrated Below, Washer

Models: 463269411

1 36

Download 36 pages 52.98 Kb

Page 22

Image 22

Attach top shelf with swing panel to side panel using three 1/4-20x1/2”screws, 7mm lock washers.

Only left side shown for assmebly, attach top shelf to right side panel in the same way.

Top shelf

Swing panel

7mm lock washer

1/4-20x1/2” screw

Left side panel

Insert front brace between cart side panels. Secure using two #10-24x3/8”screws, 5mm lock washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED AS ILLUSTRATED BELOW.

5mm Lock	#10-24x3/8”
Washer	Screw

Page 22

Image 22

Char-Broil 463269411 Note Make Sure That The Front Brace Is Mounted As Illustrated Below, Left side panel, 5mm Lock, Screw

Contents

Serial Number Estimated assembly time 30-40 minutesPlease call Date PurchasedSafety Symbols INSTALLER/ASSEMBLERTABLE OF CONTENTS DANGERCALIFORNIA PROPOSITION Installation Safety PrecautionsWash your hands after handling this product LP Cylinder Removal, Transport and Storage USE AND CARENever fill a cylinder beyond 80% full LP Liquefied Petroleum GasLP Cylinder Exchange Leak test new and exchanged LP cylinders BEFORE connecting to grillFor your safety LP Cylinder Leak TestLeak Testing Valves, Hose and Regulator Outdoor gas appliance is not intended to be installed in or on a boatOutdoor gas appliance is not intended to be installed in or on an RV Do not use grill until leak-testedDo not let children operate or play near grill Safety TipsFor Safe Use of Your Grill and to Avoid Serious Injury Do not block holes in sides or back of grillIgnitor Lighting continued Turn controls and gas source or tank OFF when not in useGeneral Grill Cleaning Match-LightingVERY IMPORTANT Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill 1. Turn gas OFF at control knobs and LP cylinder3. Turn the light switch to “ON” Bulb ReplacementBulb Specification ˙ Keep any electrical supply cord away from any heated surfaceDo not use this appliance if the circuit does not have GFI protection Cleaning the LensDo not plug this appliance into an indoor circuit PERIOD OF COVERAGE LIMITED WARRANTYSCOPE OF COVERAGE TYPE OF FAILURE COVERAGEDescription PARTS LISTDescription NOT PicturedA MMM C B OOO PARTS DIAGRAM GJ J J I I I D K K K K X E U U U ULocking caster Fixed caster ASSEMBLY OF LEFT CARTFront Bottom shelf1/4-20x1/2” screw 7mm lock washer 1/4-20x1/2” screwInside shelf NOTE MAKE SURE THAT THE FRONT BRACE IS MOUNTED AS ILLUSTRATED BELOW#10-24x3/8” screw Shelf bracket1/4-20x1/2” 7mm lock screw washer Back panelpanel Drawer front panel Drawer frameDrawer frame #10-24x3/8” ScrewLocking caster Fixed caster ASSEMBLY OF RIGHT CARTFront Bottom shelf1/4-20x1/2” screw 7mm lock washer Left side panel NOTE MAKE SURE THAT THE FRONT BRACE IS MOUNTED AS ILLUSTRATED BELOWTop shelf Swing panel 7mm lock washer 1/4-20x1/2” screw 5mm LockFront door panel Back panelAttach side panels to bottom shelf using three ASSEMBLY OF MIDDLE CARTRear FrontTemperature gauge Temperature gauge stem Control panel Back of the panelLower back panel Inside Connect Adapter wire harness and Light wire harnessAdapter Light wire harness Adapter wire harnesstwo #8x3/8” self-tapping screws on each side Secure using two #8x3/8” self-tapping screws each sideInsert front brace under control panel and between cart side panels Upper back panelself-tapping screw Front bracePage flare-up emitters must be placedkeeping both flat walls Note Some parts omitted forHeat diffuser clarity of illustrationCylinder screw at rear of cart during use, transport, and storageGrease tray Always keep LP cylinders in upright positionProblem TroubleshootingPrevention/Solution GAS ISSUESPrevention/Solution Troubleshooting continuedProblem AUTO-CLEANCheck Procedure Troubleshooting - Electronic IgnitionProblem Ignition Prevention/SolutionWarranty Registration Department P.O. Box Columbus, GA