10
Connect each of the wires from the main burner electrodes into the back of the Electronic Ignition Module. Total (4) connections, shown A.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections, shown A.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart partition panel with
the nut, shown B.-
Insert AA battery into ignition module, negative ( ) end first. Then put on the cap, shown C.
A
Electronic ignition module
(a) 1
2
(b) 3 4
B | Cart partition | Nut |
| panel |
Electronic |
|
ignition module |
|
C | Cap |
- | + |
| AA battery |
11
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door.
Right door
PRESS
Top of door
Hinge pin on bottom of door
Left door | 29 |
|
