Configuration | Set the product in DMX mode to control with a DMX controller. | |
(DMX) | 1. | Connect the product to a suitable power outlet. |
| 2. | Turn the product on. |
| 3. | Connect a DMX cable from the DMX output of the DMX controller to the DMX input |
|
| socket on the product. |
Starting Address | When selecting a starting DMX address, always consider the number of DMX channels | |
| the selected DMX mode uses. If you choose a starting address that is too high, you could | |
| restrict the access to some of the product’s channels. | |
| The Intimidator™ Spot LED 250 uses up to 13 DMX channels in its | |
| mode, which defines the highest configurable address to 500. | |
| If you are not familiar with the DMX protocol, download the DMX Primer from | |
| www.chauvetlighting.com. | |
| To select the starting address, do the following: | |
| 1. | Press <MODE/ESC> repeatedly until 001 shows on the display. |
| 2. | Press <ENTER>. |
| 3. | Use <UP> or <DOWN> to select the starting address. |
| 4. | Press <ENTER>. |
DMX | The Intimidator™ Spot LED 250 has two DMX personalities, an | |
Personalities | a | |
| To choose which DMX personality to use, follow the steps below: | |
| 1. | Press <MODE/ESC> repeatedly until either 13CH (to choose the |
|
| personality) or 8CH (to choose the |
| 2. | Press <ENTER>. |
Page 10 of 20 | Intimidator™ Spot LED 250 User Manual Rev. 11 |