3.SETUP
AC Power
The Intimidator™ Spot LED 250 has an
To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure the product has an appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Disconnect the product from power before replacing the fuse.
Fuse Replacement
Power Linking
1.Disconnect product from power.
2.Using a
3.Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4.Insert the fuse holder back in place,
The product provides power linking via the Edison outlet located in the back of the unit. Please see the diagram below for further explanation.
Power Linking | 1st Product | |
Diagram |
| 2nd Product |
|
|
Other Products
You can power link up to 6 Intimidator™ Spot LED 250 units on 120 VAC or up to 11 Intimidator™ Spot LED 250 units on 230 VAC.
The power linking diagram shown above corresponds to the North American version of the product ONLY! If using the product in other markets, you must consult with the local CHAUVET® distributor as power linking connectors and requirements may differ in your country or region.
Intimidator™ Spot LED 250 User Manual Rev. 11 | Page 7 of 20 |