Changing
Gobos
To change the gobos in the Intimidator™ Spot LED 250, you do not need to remove the gobo wheel. Simply:
1.Turn off and disconnect product from power.
2.Place the product on a flat, level surface with the front facing up.
3.Open the
4.Rotate the gobo wheel until the gobo that needs replacing is accessible.
5.Separate the gobo holder assembly away from the gobo wheel by pushing it forward and up. Be careful not to push the gobo out of the gobo plate.
6.Extract the gobo holder by pulling it backwards out of the product.
7.On a flat surface, remove the expansion ring that holds the gobo in place and remove the gobo from the gobo plate.
8.Insert a new gobo and hold it in place with the expansion ring.
9.To
10.Push the gobo holder assembly inwards. DO NOT force the gobo holder into the gobo wheel slot. Slightly move the holder from
11.Push cover back into position.
Gobo Replacement Diagram
Gobo Holder Removal
Expansion Ring
Gobo
Gobo Holder
AssemblyEasy-access
Panel
Gobo Wheel Detail Views
Intimidator™ Spot LED 250 User Manual Rev. 11 | Page 17 of 20 |