6159939020 SD25 Series Screwdrivers

Mapping Outputs for a Single-Spindle

Typically, the LEDs and headlights on the screwdriver work in the following way:

Headlights turn on while the screwdriver is running in forward or reverse.

NOTE:

Yellow, green and red LEDs chase each other in a

?

counterclockwise direction while the screwdriver is in reverse.

 

• Green LEDs turn on to indicate a successful cycle completion achieving target torque/angle within acceptable range.

• Yellow LEDs turn on to indicate lower than acceptable torque/angle.

• Red LEDs turn on to indicate higher than acceptable torque/angle.

The screwdriver outputs are software selectable using VS. To operate the screwdriver as a single- spindle tool, assign the Cycle Good output to Output 2, Cycle Bad output to Output 3, Output 8 (Timed Copy) to Output 7 and the Ready output to Output 8. The typical outputs for operating the screwdriver as a single-spindle tool are shown below.

NOTE: The time delay for Output 8 (Timed Copy) can be adjusted ? using the Timers tab in VS. For details, refer to the Visual

Supervisor User’s Guide (part number 39-30-34823).

Page 18

39-30-40409

Page 26
Image 26
Chicago Pneumatic SD25 user manual Mapping Outputs for a Single-Spindle, Supervisor User’s Guide part number