Cino F700BT Clone Function, The below host interface related parameters will be impacted by clone function:

Reference Manual

Wireless FuzzyScan

Getting Started

Clone Function

For the user’s convenience, the clone function will help you to clone the host interface related parameters (please refer to following table for details) from one of the paired scanners to the rest of paired scanners under PICO mode. You can use one of the paired scanners to set the host interface related parameters first and then scan “Save Configuration” command. After that, please take the other paired scanners to scan “Clone” command one by one to clone the host interface related parameters.

Please ensure to keep those paired scanners in connected status when you use the “Clone” function. Because the host interface related parameters can’t be cloned to the paired scanner in disconnected status.

Save Configuration Clone

The below host interface related parameters will be impacted by clone function:

Data Transmission Parameter		Serial Interface Control
Field Delimiter		Handshaking Protocol
Data Transmission Format		Intermessage Delay
		Interfunction Delay
Host Interface Control
Host interface Selection		Intercharacter Delay
		Baud Rate
Keyboard Interface Control
Keyboard Layout		Data Frame
Intermessage Delay		Time Out Control
Interfunction Delay
		Wand Emulation Control
Intercharacter Delay		Output Polarity
Caps Lock Control		Initial Signal State
Caps Lock Release Control		Margin Time
Function Key Emulation		Module Time
Key Pad Emulation		Narrow/Wide Ratio
Upper/Lower Case		Code39 Emulation
	6