Cino F700BT END, Clone, PROGRAM, (SYSLIST), FIN (Finish), User Default, Master Default, Factory Default, Save User Default, Save Configuration, PowerTool Host Link

Reference Manual

Wireless FuzzyScan

Appendix

System Commands

PROGRAM	Save Configuration
(Enter Programming Mode)
	Sleep
FIN (Finish)	Clone
	Paging
END	Factory Default
(Exit Programming Mode)
	PowerTool Host Link
System Information List	Master Default
(SYSLIST)

￿Factory Default: After scanning” Factory Default” command, all parameters will be returned to factory default value (The radio link will be disconnected and the scanner will revert to uninstall state).

￿Master Default: After scanning “Master Default” command, the scanner will remain the pre-set parameters of Host Interface Selection, Keyboard Interface Control (except Record Suffix; Preamble; Postamble), Serial Interface Control (except Record Suffix; Preamble; Postamble), Wand/Laser Emulation Control, Bluetooth Device Name, Bluetooth PIN Code, and Out-of-range Scanning, the rest of parameters will be returned to default value (The radio link is still keep on).

Save User Default User Default

￿User Default: After scanning” Save User Default” command, all current parameters will be stored to the flash memory. Once you change the parameter and would like to return to previous setting, please scan “User Default”.

77