Cino F700BT ♦ Out-of-rangeScanning, Sleep Time-outControl ♦, 1 sec, Enable, 5 secs, 7 secs, 9 secs, 3 secs ￿, Disable ￿, 1 minute ￿, 0-99minutes, Out-of-range

Reference Manual

Wireless FuzzyScan

Configure Your FuzzyScan

Operation Control

♦ Out-of-range Scanning, Sleep Time-out Control ♦

PROGRAM			F_DEFAULT
Family Code Selection	P.C	Parameter Selection	Option Code
Out-of-range Scanning	SS	Disable ￿	0
	SS	Enable	1
Link Supervision Time-out	SS	1 sec	0
		3 secs ￿
	SS		1
	SS	5 secs	2
	SS	7 secs	3
	SS	9 secs	4
		Only available in PAIR & PICO modes
Sleep Time-out of Connect State	SS	6 (x5) minutes ￿	FIN
	MS	0-99 (x5) minutes	(2 digits)
		If you don’t want the scanner to enter sleep mode, please set time-out to “0”
Sleep Time-out of Disconnect State	SS	1 minute ￿	FIN
	MS	0-99 minutes	(2 digits)

If you don’t want the scanner to enter sleep mode, please set time-out to “0”

￿Out-of-range Scanning When radio link is built between the scanner and remote host device, the scanner will transmit each scanned data right after scanning the barcode data. However, the scanner is preset for unable to scan any barcode data when it loses the radio connection. You can enable the Out-of-range Scanning function to continue scanning barcode data into memory buffer until radio link resumed.

￿The Link Supervision Time-out is a pre-defined radio link supervision timeout setting. The scanner will supervise the radio link status every preset seconds.

￿The Sleep Time-out Control can be set under radio connection or disconnection state. If the scanner is not used within the preset time-out duration, it will automatically enter “Sleep State” for power saving purpose. You are able to disable this function by setting the time-out duration to “0”.

57