3-5
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
OL-5048-06
Chapter3 Mounting Overview
LEDs
LEDs
The LEDs indicate the status, radio activity, and Ethernet activity. The LEDs are mounted on the back
of the housing (see Figure 3-2).
Figure 3-2 LEDs
For additional information on LED indications, refer to the “Troubleshooting Autonomous Access
Points and Bridges” section on page 4-1 or the “Troubleshooting Lightweight A ccess Points” section on
page 5-1.

Autonomous Access Point/Bridge

When the autonomous access point/bridge running Cisco IOS Release 12.3(4)JA is initially powered-up,
the unit defaults to a root access point with the radio disabled an d no default SSID. To allow client
associations, you must configure an SSID and enable the r adio interface (refer to the Cisco IOS Software
Configuration Guide for Access Points).
When the autonomous access point/bridge running Cisco IOS Release 12.3(2) JA2 and earlier is initially
powered-up, the bridge installation mode is activated and the unit attempts to associate to a root bridge
for 60 seconds. If it is unable to associate with a root bridge, it automatically assumes the root bridge
role.
RRadio LED EEthernet LED
SStatus LED IInstall LED
117061
RS
I
E