Cisco Systems 3000 Series , 1

Follow these steps to install the switch module in the blade enclosure. The illustrations in this section

show the Cisco Catalyst Blade Switch 3020 for HP switch module. The instructions are the same for

the Cisco Catalyst Blade Switch 3120 for HP switch module.

Step 1 If you have not already done so, touch the static-protective package that contains the switch

module to an unpainted metal part of the blade enclosure for at least 2 seconds.

Step 2 Remove the switch module from its static-protective package.

Step 3 Remove the interconnect blank from the bay where you plan to install the switch module, if

one is present, and install the switch module. (See Figure 4.)

Figure 4 Removing the Interconnect Module Blank from the Blade Enclosure

1Lever for the interconnect module blank

153142

Contents

Main GETTING STARTED GUIDE Cisco Catalyst Blade Switch 3000 Series for HP Getting Started Guide 1 2 Shipping Box Contents Cisco Switch Module Descriptions Cisco Catalyst Blade Switch 3120 for HP Page Cisco Catalyst Blade Switch 3020 for HP Port Description Port Description 3 4 Before you install the switch module in the blade enclosure, consider these points: 1 12 : Step 5 Slide the switch module into the bay until it stops. (See Figure 5.) Figure 5 Installing the Switch Module into the Blade Enclosure Interconnect Module Bay 1 5 to the Switch Module and Running Express Setup Page Page Using Express Setup Page Page 6 Using the Device Manager Page Using the Command-Line Interface Using the Onboard Administrator CLI Other Management Options 7 Catalyst Blade Switch 3120 for HP) Stack Cabling Configurations Connecting the StackWise Plus Cables 8 Connect to 10/100/1000 Ports Install and Connect to Devices in the 10-Gigabit Ethernet Slots Verify Port Connectivity 9 Resetting the Switch Module Accessing Help Online For More Information 10