Cisco Systems 3000 Series Using the Command-Line Interface

Figure 10 Device Manager Page for the Cisco Catalyst Blade Switch 3020 for HP

Step 3 Use the device manager to perform basic switch module configuration and monitoring. See the

device manager online help for more information.

Step 4 For more advanced configuration, download and run the Cisco Network Assistant, which is

described in the next section.

Using the Command-Line Interface

You can enter Cisco IOS commands and parameters through the CLI. Access the CLI either by

connecting your PC directly to the switch module console port or through a Telnet session from a

remote PC or workstation.

Follow these steps:

Step 1 Connect the supplied RJ-45-to DB-9 adapter cable to the standard 9-pin serial port on the PC.

Connect the other end of the cable to the console port on the switch module.

Step 2 Start a terminal-emulation program on the PC.

Contents

Main GETTING STARTED GUIDE Cisco Catalyst Blade Switch 3000 Series for HP Getting Started Guide 1 2 Shipping Box Contents Cisco Switch Module Descriptions Cisco Catalyst Blade Switch 3120 for HP Page Cisco Catalyst Blade Switch 3020 for HP Port Description Port Description 3 4 Before you install the switch module in the blade enclosure, consider these points: 1 12 : Step 5 Slide the switch module into the bay until it stops. (See Figure 5.) Figure 5 Installing the Switch Module into the Blade Enclosure Interconnect Module Bay 1 5 to the Switch Module and Running Express Setup Page Page Using Express Setup Page Page 6 Using the Device Manager Page Using the Command-Line Interface Using the Onboard Administrator CLI Other Management Options 7 Catalyst Blade Switch 3120 for HP) Stack Cabling Configurations Connecting the StackWise Plus Cables 8 Connect to 10/100/1000 Ports Install and Connect to Devices in the 10-Gigabit Ethernet Slots Verify Port Connectivity 9 Resetting the Switch Module Accessing Help Online For More Information 10