Cisco Systems 3550 Attaching the Brackets to the Switch, Attaching the RPS Connector Cover, 2-13

Chapter 2 Switch Installation

Installing the Switch

Attaching the Brackets to the Switch

Figure 2-15shows how to attach a 19-inch bracket to one side of the switch. Follow the same steps to attach the second bracket to the opposite side.

Note On the Catalyst 3550-24-FX switch, remove the screws that are in the side of the chassis before you attach the brackets.

Figure 2-15 Attaching the 19-Inch Brackets for Wall Mounting

100-240V~ 5-3A 50/60Hz

CONSOLE

Phillips truss-head screws

51368

Attaching the RPS Connector Cover

If you are not using an RPS with your switch, use the two Phillips pan-head screws to attach the RPS connector cover to the back of the switch, as shown in Figure 2-16.

Warning If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch.

Statement 265

Figure 2-16 Attaching the RPS Connector Cover on the Switch

DC 1

RPS

Phillips connector cover

pan-headRPS

screwsconnector

100-240V~ 5-3A 50/60Hz

CONSOLE

86483

Catalyst 3550 Switch Hardware Installation Guide

OL-6155-01 2-13