Cisco Systems 3550 manual

Appendix D Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

After you complete the setup program, the switch can run the default configuration that you created. If you want to change this configuration or want to perform other management tasks, use one of these tools:

•CLI

•Device manager from your browser (for one switch)

•Network Assistant (for one or more switches)

To use the CLI, enter commands at the Switch> prompt through the console port or through the network by using Telnet. For configuration information, see the switch software configuration guide or the switch command reference.

To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide.

Catalyst 3550 Multilayer Switch Hardware Installation Guide

OL-6155-01 D-7