25
Catalyst6000 Family Network Analysis Module Installation and Configuration Note
78-10406-05
Configuring the NAM
Step 5 Configure the IP address and subnet mask by entering this command:
root@localhost# ip address ip-address subnet-mask
Step 6 Configure the IP broadcast address by entering this command:
root@localhost# ip broadcast broadcast-address
Step 7 Configure the IP host name used in the CLI prompt, show commands, and log messages by entering
this command:
root@localhost# ip host name
Step 8 Configure the default gateway by entering this command:
root@localhost# ip gateway default-gateway
Step 9 Configure the domain name for the NAM by entering this command:
root@localhost# ip domain domain-name
Step 10 Configure one or more IP addresses as DNS name servers by entering this command:
root@localhost# ip nameserver ip-address [ip-address]
Step 11 Verify the NAM configuration by entering this command:
root@localhost# show ip
Step 12 Configure the SNMP syslocation MIB variable by entering this command:
root@localhost# snmp location location-string
Note The MIB variables in Step 13 and Step 14 must be valid DisplayString texts, each with a
maximum length of 64 characters.
Step 13 Set the SNMP sysContact MIB variable by entering this command:
root@localhost# snmp contact contact-string
Step 14 Set the SNMP sysName MIB variable by entering this command:
root@localhost# snmp name name-string
Note You can delete the SNMP location, SNMP contact, or SNMP name by entering the respective
command without any parameters.
Step 15 Set the SNMP agent community string parameter password for read-write access by entering this
command:
root@localhost# snmp community community-string rw
Step 16 Set the SNMP agent community string parameter password for read-only access by entering this
command:
root@localhost# snmp community community-string ro
Note Clear the SNMP community string with the snmp delete community community-string
command.