27
Catalyst6000 Family Network Analysis Module Installation and Configuration Note
78-10406-05
Configuring the NAM
sysDescr "Catalyst 6000 Network Management Module (WS-X6380-NAM)"
sysObjectID 1.3.6.1.4.1.9.5.1.3.1.1.2.223
sysContact "Jane Doe, Cisco Systems, (408) 111-1111"
sysName "6k-NAM - Slot 2"
sysLocation "Cisco Lab, Building X, Floor 1"
root@localhost#
Configuring VLANs
You do not need to configure a VLAN as the NAM management port because that port automatically
synchronizes to the VLAN assigned to interface sc0 on the supervisor engine.
Note You cannot set the NAM management port VLAN with the set vlan mod/port command.
Using NetFlow Data Export as a Traffic Source
To use NetFlow Data Export (NDE) as a traffic source for the NAM, you must enable the NetFlow
Monitor option to allow the NAM to receive the NDE stream. The statistics are presented on reserved
ifIndex.3000.
Note Configuration of the Multilayer Switch Function Card (MSFC) is necessary for using the NetFlow
feature. For information on configuring NDE, refer to the Catalyst 6000 Family Software
Configuration Guide.
To enable the NetFlow Monitor option, perform these tasks:
This example shows how to enable the NetFlow Monitor option and verify that it is enabled:
Console> (enable) set snmp extendedrmon netflow enable 2
Snmp extended RMON netflow enabled
Console> (enable) show snmp
RMON: Enabled
Extended RMON Netflow Enabled : Module 2
Traps Enabled:
None
Port Traps Enabled: None
Task Com man d
Step1 Enable the NetFlow Monitor option. set snmp extendedrmon netflow [enable |
disable] mod
Step2 Verify that the NetFlow Monitor option is
enabled.
show snmp
Step3 Enable NDE. set mls nde enable