57
Catalyst6000 Family Network Analysis Module Installation and Configuration Note
78-10406-05
Administering the NAM
The NAM also supports CLI commands for the supervisor engine, which are described in more detail in
the Catalyst 6000 Family Command Reference publication.
Cisco IOS Commands
The NAM also supports these CLI commands, which are described in more detail in the Catalyst 6000
Family IOS Command Reference publication. These commands are grouped according to mode. These
sections describe the Cisco IOS commands that interact with the NAM:
•Exec Commands, page 57
•Configuration Commands, page 58

Exec Commands

The following commands are all performed in exec mode:
traceroute [-Inv] [-f first_ttl] [-m max_ttl]
[-p port] [-s src_addr] [-t tos] [-w waittime]
destination host name | IP address
[packetlen]
The following options are supported:
-I—Uses ICMP ECHO instead of UDP datagrams.
-n—Prints hop addresses numerically.
-v—Provides verbose output.
-f first_ttl—Sets the initial time-to-live used in the first outgoing packet.
-m max_ttl—Sets the maximum time-to-live (max number of hops) used.
-p port—Sets the base UDP port number used in probes.
-s src_addr—Forces the source address to be something other than the IP
address of the interface the packet is sent on.
-t tos—Sets the type-of-service in packets to the following value.
-w waittim—Sets the time (in seconds) to wait for a response to a probe.
upgrade
ftp://user:passwd@host/full-path/filename
Upgrades the maintenance software from the specified location.
Command Description
Command Description
show module
Displays installed modules, versions, and states.
Note This command does not show the signature level.
reload Reloads the entire switch.
show running-config Displays the configuration that is currently running.
show startup-config Displays the saved configuration.
hw-module module slot_number reset Resets the module into the application image by default.
hw-module module slot_number reset hdd:2 Resets the module into the maintenance image.
hw-module module slot_number shutdown Resets the module into the maintenance image.
show interfaces Gigabit slot_number/port_number Displays status of the interface.
show interfaces switchport module slot_number Displays current switch settings for the interfaces.