Manuals / Cisco Systems / Computer Equipment / Network Router

Cisco Systems AIRCAP3602ITK9, AIRCAP3602IAK9RF specifications Pre-Installation Configuration Setup

Models: AIRCAP3602ISK9 AIRCAP3602EAK9 AIRCAP3602IAK9RF AIRCAP3602ITK9

1 40

Download 40 pages 31.6 Kb

Page 12

Pre-Installation Configuration Setup

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in Figure 4.

Figure 4 Pre-Installation Configuration Setup

Controller

Layer 3 devices

Cisco Aironet access points

272488

To perform pre-installation configuration, perform the following steps:

Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate Cisco wireless LAN controller guide.

a.Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management and AP-Manager Interface.

b.Configure the switch to which your access point is to attach. See the Cisco Wireless LAN Controller Configuration Guide, Release x.x for additional information.

c.Set the Cisco wireless LAN controller as the master so that new access points always join with it.

d.Make sure DHCP is enabled on the network. The access point must receive its IP address through DHCP.

12

Image 12

Cisco Systems AIRCAP3602ITK9 Pre-Installation Configuration Setup, Controller Layer 3 devices Cisco Aironet access points

Contents

Cisco Aironet 3600 Series Lightweight Access Points GETTING STARTED GUIDE 2 Introduction to the Access Point 1 About this Guide 3 Safety Instructions IMPORTANT SAFETY INSTRUCTIONStranslated safety warnings that accompanied this device. Statement SAVE THESE INSTRUCTIONS 20A. Statement 5 Configurations 4 UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported 6 Access Point Ports and Connectors LED indicator Figure 2 Access Point LED Indicator top-3602I Model272377 7 Configuring the Access Point The Controller Discovery Process Preparing the Access Point Installation Summary Performing a Pre-Installation Configuration Pre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access points Step 2 Apply power to the access point 2106 controller WS-C3550, WS-C3560, and WS-C3750 switchesC1880 switch 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms c. If the access point shuts down, check the power source 8 Mounting the Access Point 9 Deploying the Access Point on the Wireless Network 10 Installing Modules Installing a Module Step 5 Screw down the thumb screws on the module 11 Troubleshooting Guidelines for Using Cisco Aironet Lightweight Access PointsUsing DHCP Option Checking the Access Point LED Status LED LED Status Indications continued Troubleshooting the Access Point Join Process 12 Declarations of Conformity and Regulatory Information Tested To Comply With FCC Standards FOR HOME OR OFFICE USE Access Point Models Module Models VCCI Statement for Japan Guidelines for Operating Cisco Aironet Access Points in Japan Japanese TranslationEnglish Translation 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry CanadaCanadian Compliance Statement Access Point Models European Community, Switzerland, Norway, Iceland, and LiechtensteinModule Models Page Health & Safety-EN60950-1 2005 EN 50385 The following standards were appliedEMC-EN 301.489-1 v1.8.1 EN 301.489-17 Radio-EN 300 328 v 1.7.1 EN 301.893 v Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Administrative Rules for Cisco Aironet Access Points in Taiwan Chinese Translation Administrative Rules for Low-power Radio-Frequency Devices Article Operation of Cisco Aironet Access Points in Brazil Regulatory Information Declaration of Conformity Statements Portuguese Translation 13 Configuring DHCP Option 43 and DHCP Option Cisco AP c3600-ServiceProviderCisco AP c3600 14 Access Point Specifications Type + Length + ValueSpecification Category refer to Channels and Maximum Power Settings for Cisco Aironet Access Point Specifications continued 15 Obtaining Documentation and Submitting a Service Request