Manuals / Cisco Systems / Computer Equipment / Network Router

Cisco Systems AIRCAP3602EAK9, AIRCAP3602ITK9 Declaration of Conformity for RF Exposure

Models: AIRCAP3602ISK9 AIRCAP3602EAK9 AIRCAP3602IAK9RF AIRCAP3602ITK9

1 40

Download 40 pages 31.6 Kb

Page 30

Declaration of Conformity for RF Exposure

This device also conforms to the EMC requirements of the Medical Devices Directive 93/42/EEC.

Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate Compliance.

The product carries the CE Mark:

Declaration of Conformity for RF Exposure

This section contains information on compliance with guidelines related to RF exposure.

Generic Discussion on RF Exposure

The Cisco products are designed to comply with the following national and international standards on Human Exposure to Radio Frequencies:

•US 47 Code of Federal Regulations Part 2 Subpart J

•American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers / IEEE C 95.1 (99)

•International Commission on Non Ionizing Radiation Protection (ICNIRP) 98

•Ministry of Health (Canada) Safety Code 6. Limits on Human Exposure to Radio Frequency Fields in the range from 3kHz to 300 GHz

•Australia Radiation Protection Standard

To ensure compliance with various national and international Electromagnetic Field (EMF) standards, the system should only be operated with Cisco approved antennas and accessories.

This Device Meets International Guidelines for Exposure to Radio Waves

The 3600 series device includes a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves (radio frequency electromagnetic fields) recommended by international guidelines. The guidelines were developed by an independent scientific organization (ICNIRP) and include a substantial safety margin designed to ensure the safety of all persons, regardless of age and health.

30

Image 30

Cisco Systems AIRCAP3602EAK9, AIRCAP3602ITK9 Declaration of Conformity for RF Exposure, Generic Discussion on RF Exposure

Contents

Cisco Aironet 3600 Series Lightweight Access Points GETTING STARTED GUIDE 2 Introduction to the Access Point 1 About this Guide translated safety warnings that accompanied this device. Statement 3 Safety InstructionsIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS 20A. Statement 5 Configurations 4 UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported 6 Access Point Ports and Connectors LED indicator Figure 2 Access Point LED Indicator top-3602I Model272377 7 Configuring the Access Point The Controller Discovery Process Preparing the Access Point Installation Summary Performing a Pre-Installation Configuration Pre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access points C1880 switch Step 2 Apply power to the access point2106 controller WS-C3550, WS-C3560, and WS-C3750 switches 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms c. If the access point shuts down, check the power source 8 Mounting the Access Point 9 Deploying the Access Point on the Wireless Network 10 Installing Modules Installing a Module Step 5 Screw down the thumb screws on the module Using DHCP Option 11 TroubleshootingGuidelines for Using Cisco Aironet Lightweight Access Points Checking the Access Point LED Status LED LED Status Indications continued Troubleshooting the Access Point Join Process 12 Declarations of Conformity and Regulatory Information Tested To Comply With FCC Standards FOR HOME OR OFFICE USE Access Point Models Module Models VCCI Statement for Japan English Translation Guidelines for Operating Cisco Aironet Access Points in JapanJapanese Translation 03-6434-6500 Statement 371-Power Cable and AC Adapter Industry CanadaCanadian Compliance Statement Access Point Models European Community, Switzerland, Norway, Iceland, and LiechtensteinModule Models Page EMC-EN 301.489-1 v1.8.1 EN 301.489-17 Health & Safety-EN60950-1 2005 EN 50385The following standards were applied Radio-EN 300 328 v 1.7.1 EN 301.893 v Declaration of Conformity for RF Exposure Generic Discussion on RF Exposure This Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Administrative Rules for Cisco Aironet Access Points in Taiwan Chinese Translation Administrative Rules for Low-power Radio-Frequency Devices Article Operation of Cisco Aironet Access Points in Brazil Regulatory Information Declaration of Conformity Statements Portuguese Translation 13 Configuring DHCP Option 43 and DHCP Option Cisco AP c3600-ServiceProviderCisco AP c3600 Specification 14 Access Point SpecificationsType + Length + Value Category refer to Channels and Maximum Power Settings for Cisco Aironet Access Point Specifications continued 15 Obtaining Documentation and Submitting a Service Request