Manuals / Cisco Systems / Computer Equipment / Network Router

Cisco Systems AIRCAP3602ISK9, AIRCAP3602ITK9, AIRCAP3602IAK9RF Access Point Models, Module Models

Models: AIRCAP3602ISK9 AIRCAP3602EAK9 AIRCAP3602IAK9RF AIRCAP3602ITK9

1 40

Download 40 pages 31.6 Kb

Page 23

Access Point Models

Certification Number

AIR-CAP3602E-A-K9LDK102075

AIR-CAP3602I-A-K9

Module Models

Certification Number

AIR-RM3000AC-A-K9LDK102086

Manufacturer:

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

This device operates in the 5150-5250MHz and 5470-5725MHz bands and is therefore restricted to indoor operation only per FCC guidance.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase separation between the equipment and receiver.

•Connect the equipment to an outlet on a circuit different from which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician.

23

Image 23

Cisco Systems AIRCAP3602ISK9, AIRCAP3602ITK9, AIRCAP3602IAK9RF, AIRCAP3602EAK9 Access Point Models, Module Models

Contents

GETTING STARTED GUIDE Cisco Aironet 3600 Series Lightweight Access Points1 About this Guide 2 Introduction to the Access PointSAVE THESE INSTRUCTIONS 3 Safety InstructionsIMPORTANT SAFETY INSTRUCTIONS translated safety warnings that accompanied this device. Statement20A. Statement External Antennas 5 Configurations4 Unpacking Countries Supported Internal AntennasRegulatory Domains 6 Access Point Ports and Connectors 272377 LED indicatorFigure 2 Access Point LED Indicator top-3602I Model The Controller Discovery Process 7 Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration Setup2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms Step 2 Apply power to the access point2106 controller WS-C3550, WS-C3560, and WS-C3750 switches C1880 switchc. If the access point shuts down, check the power source 9 Deploying the Access Point on the Wireless Network 8 Mounting the Access PointInstalling a Module 10 Installing ModulesStep 5 Screw down the thumb screws on the module Checking the Access Point LED 11 TroubleshootingGuidelines for Using Cisco Aironet Lightweight Access Points Using DHCP OptionStatus LED LED Status Indications continued Troubleshooting the Access Point Join Process Tested To Comply With FCC Standards FOR HOME OR OFFICE USE 12 Declarations of Conformity and Regulatory InformationModule Models Access Point ModelsVCCI Statement for Japan 03-6434-6500 Guidelines for Operating Cisco Aironet Access Points in JapanJapanese Translation English TranslationCanadian Compliance Statement Statement 371-Power Cable and AC AdapterIndustry Canada Module Models Access Point ModelsEuropean Community, Switzerland, Norway, Iceland, and Liechtenstein Page Radio-EN 300 328 v 1.7.1 EN 301.893 v Health & Safety-EN60950-1 2005 EN 50385The following standards were applied EMC-EN 301.489-1 v1.8.1 EN 301.489-17Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation Administrative Rules for Cisco Aironet Access Points in TaiwanAdministrative Rules for Low-power Radio-Frequency Devices Article Regulatory Information Operation of Cisco Aironet Access Points in BrazilPortuguese Translation Declaration of Conformity StatementsCisco AP c3600 13 Configuring DHCP Option 43 and DHCP OptionCisco AP c3600-ServiceProvider Category 14 Access Point SpecificationsType + Length + Value SpecificationAccess Point Specifications continued refer to Channels and Maximum Power Settings for Cisco Aironet15 Obtaining Documentation and Submitting a Service Request