Cisco Systems CATALYST 2950 Install SFP and GBIC Modules and Connect to the Ports, SFP module

Install SFP and GBIC Modules and Connect to the Ports

Follow these steps:

Step 1 Grasp the module on the sides, and insert it into the switch slot until you feel the connector snap into place.

1	2	3
			4	5
					6	7
							8
								9	10	11
											12	13
													14	15
															16

16X

SFP module

Catalyst

1

1

2950 SERIES

2

2

1	Catalyst	2950	SERIES
	2

GBIC module

Step 2 Insert an appropriate cable into the module port. Insert the other cable end into the other device.

1	2	3
			4	5
					6	7
							8	9
									10	11
											12	13	14
														15	16

16X

SFP module port

Catalyst

1

1

2950 SERIES

2

2

1	Catalyst	2950	SERIES
	2

GBIC module port

For a list of supported modules, refer to the release notes on Cisco.com. For detailed instructions on installing and removing modules, refer to the documentation that came with the SFP or GBIC module.

Caution Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary.

After you connect to the switch port, the port LED turns amber while the switch establishes a link. This process takes about 30 seconds, and then the LED turns green when the switch and the target device have an established link. If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See the “In Case of Difficulty” section on page 19 for information about online assistance.

15