Cisco Systems CISCO7206 quick start Performing a Basic Configuration Using the Setup Facility

Performing a Basic Configuration Using the Setup Facility

If you do not plan to use AutoInstall, do not connect the router’s serial (WAN) cable to the channel service unit/data service unit (CSU/DSU). If the WAN cable is not connected, the router boots from Flash memory and goes automatically into the setup facility.

Note You can run the setup facility any time you are at the enable prompt (#) by entering the setup command.

If the serial (WAN) cable is connected to the CSU/DSU and the router does not have a configuration stored in NVRAM, the router attempts to run AutoInstall at startup. The router may take several minutes to determine that AutoInstall is not set up to a remote TCP/IP host. Once the router determines that AutoInstall is not configured, it defaults to the setup facility.

Configuring Global Parameters

When you first start the setup program, you must configure the global parameters. These parameters are used for controlling system-wide settings. Complete the following steps to enter the global parameters:

1.Connect a console terminal to the console port on the I/O controller.

2.Power on the router.

The system boots from Flash memory. After startup, the console screen displays a script and a system banner—after about

30 seconds—similar to the following. When you see this information, you have successfully booted your router:

Restricted Rights Legend

Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph

(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph

(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 7200 Software (C7200-J-M), Released Version 11.1(17)CA

Copyright (c) 1986-1996 by cisco Systems, Inc.

Compiled Sun 21-Apr-96 04:10 by

Image text-base: 0x60010890, data-base: 0x605F0000

ROM: System Bootstrap, Version 11.1(17)CA, RELEASED SOFTWARE

ROM: 7200 Software (C7200-J-M), Released Version 11.1(17)CA

router uptime is 8 minutes System restarted by reload

System image file is "c7200-j-mz", booted via tftp from 10.1.10

cisco 7206 (NPE 150) processor with 12288K/4096K bytes of memory. R4700 processor, Implementation 33, Revision 1.0 (Level 2 Cache) Last reset from power-on

Bridging software.

SuperLAT software copyright 1990 by Meridian Technology Corp). X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.

TN3270 Emulation software (copyright 1994 by TGV Inc). 4 Ethernet/IEEE 802.3 interfaces.

5 FastEthernet/IEEE 802.3 interfaces.

8 Serial network interfaces.

125K bytes of non-volatile configuration memory.

17