| | | | 6 |
| | | FAST ETHERNET | |
M II | LINK | RJ | 45 | 4 |
|
0 | | | | |
| | | ETHERNET-10BFL | |
| | | | 2 |
| FAST ETHERNET INPUT/OUTPUT CONTROLLER | |
| | | | 0 |
2
1
1Cable-management bracket
2Rack-mount bracket
53499
3M4 x 8-mm Phillips flathead screws
Brackets Front-Mounted—Chassis Recessed in Rack
Locate the rack-mount and cable-management brackets and screws (1, 2, 3 in the illustration above) and a Number 2 Phillips screwdriver.
1.Align the cable-management bracket (1) to the side of the router. Align the rack-mount bracket over it—as shown above—and insert and tighten the screws (3).
Go to the “Two-Post or Four-Post Rack Installation” section on page 10.
2.If you are not using the cable-management brackets, align the rack-mount brackets (2)—as shown above—to the router and insert and tighten the screws.
Go to the “Two-Post or Four-Post Rack Installation” section on page 10.