5
5
3
1
Cisco 7200
Series
6
4
2
0
1 2
4 |
| 6 |
|
| 5 |
| 57037 |
|
| 4 | |
| 3 |
|
|
| 1 |
|
|
| Cisco 7200 |
|
|
| Series |
|
|
3
1 | Port adapter in place | 4 | Slot guide |
|
|
|
|
2 | Port adapter lever in unlocked position | 5 | Port adapter lever in locked position |
|
|
|
|
3 | Port adapter partially removed or installed |
|
|
|
|
|
|
Replace a Port Adapter or Service Adapter
1.To remove a port adapter, place the port adapter lever in the unlocked position (2).
2.Grasp the handle and pull the port adapter from the router, about halfway out of its slot (3). If you are removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.
3.With the port adapter halfway out of the slot, disconnect all cables from the port adapter. After disconnecting the cables, pull the port adapter from its chassis slot.
4.To insert the port adapter, carefully align the port adapter carrier between the upper and the lower edges of the port adapter slot (4) and slide the new port adapter halfway into the port adapter slot (3).
5.Connect all required cables to the port adapter. After connecting all required cables, carefully slide the port adapter all the way into the slot until the port adapter is seated in the router midplane.
6.After the port adapter is properly seated, lock the port adapter lever (5).
Also see the appropriate port adapter documentation at
http://www.cisco.com/univercd/cc/td/doc/product/core/7206/port_adp/index.htm.
2 |
| 3 | 2 |
| 3 |
4 | 1 | 5 | 4 | 1 | 5 |
57038
1 | Power switch | 4 | Captive installation screws |
|
|
|
|
2 | PWR OK LED | 5 | Handle |
|
|
|
|
3 | AC/DC power input connection |
|
|
|
|
|
|
27