Cisco Systems Cisco 1712, Cisco 1711 manual Assembling Stacking Clip and Fastener

Chapter 2 Installation

Optional Installation Steps

Figure 2-8 Assembling Stacking Clip and Fastener

Push plastic fastener

through small hole at the end of the stacking clip.

H11542

After assembling the clip and fastener, follow these steps to stack the router with another device:

Step 1 Place the clip on top of the lower device, as shown in Figure 2-9 on page 2-17. Slide the clip forward so that the front tabs slide into the vent slots. Make sure that the rear hooks fit over the edge of the lower device.

	Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
2-16	OL-4050-02