Cisco Systems Cisco 2800 Installing Filler Panels in Network Module Slots, Removing Filler Panels from Network Module Slots

6
Installing Network Modules in Cisco2800 Series Routers
OL-5790-01
Installing and Removing Filler Panels in Network Module Slots
Figure8 Filler Panels for NME and NM
Installing Filler Panels in Network Module Slots
Note A network module slot must be empty before you install a filler panel.
Install filler panels as follows:
Step1 Orient the filler panel for insertion, with the captive retention screw at the right side.
Step2 Insert the filler panel into the far right edge of the slot.
Step3 Guide the inner end of the filler panel into the square hole at the rear of the network module slot, and
align the retention screw with the threaded screw hole in the chassis, slot divider, or adjacent filler panel.
Note You may be securing the filler panel to the router chassis, to another filler panel, or to a slot
divider, depending on its installation location.
Step4 Tighten the retention screw.
Removing Filler Panels from Network Module Slots
Note A network module slot must be empty before you remove a filler panel.
To remove a filler panel, loosen the captive retention screw and pull the filler panel straight out of the
slot.
1Filler panel 3Blank panel
2Slot divider 4Filler panel
121068
T
D
M
0
A= ACT
GE 0/1
PVDM2PVDM1PVDM0AIM1AIM0
GE 0/0
S= SPEED
A= FDX
A= LINK
A
F
S
L
A
F
S
L
S
L
O
T
2
S
L
O
T
0
S
L
O
T
3
S
L
O
T
1
4
1
23