CHAPT ER
2-1
Cisco 4x InfiniBand Switch Module for IBM BladeCenter User Guide
78-17838-01
2
Installing and Configuring the Server Switch
This chapter describes installing and configuring the Server Switch Module and configuring the
password and system clock, Additional configuring includes synchronizing with NTP and extending an
InfiniBand fabric
This chapter contains the following sections:
Installing the Server Switch Module, page 2-1
Downloading Operating System Software from Cisco.com, page 2-1
Configuring the Server Switch Module, page 2-2
Connecting Beyond BladeCenter, page 2-5

Installing the Server Switch Module

To install the Cisco Server Switch Module, follow these steps:
Step1 Ensure that you are properly grounded by attaching the ESD wrist strap to bare skin and attaching the
clip on the other end to unpainted metal.
Step2 Choose the I/O slot into which you want to install the Server Switch Module. You must install the module
in I/O slot 7 or slot 9.
Step3 Refer to your BladeCenter unit documentation for standard hardware module installation instructions.

Downloading Operating System Software from Cisco.com

The operating system associated with the Cisco 4x InfiniBand HCA Expansion Card for IBM
BladeCenter can be downloaded from www.cisco.com by using the Technical Support & Documentation
link. To download the software, follow these steps:
Step1 Go to www.cisco.com and log in with your CCO user ID.
Step2 Click Technical Support & Documentation.
Step3 Click Software Downloads.
Step4 Click Server Networking & Virtualization Software.