46
Note For CE1 ISDN PRI—If you do not specify the time slots, the specified controller is configured for 30 B channels and
1 D channel. B channel numbers range 1 to 31; channel 16 is the D channel for E1. Corresponding serial interface
numbers range 0 to 30. In commands, the D channel is interface serial slot/port:15—for example, interface serial 1/0:15.
Step6 Return to privileged EXEC mode:
Gateway(config-controller)# Ctrl-Z
Gateway#
Tip To save the gateway configuration, save it to NVRAM. Refer to the “Saving Configuration Changes” section on
page 57.
Verify
To verify that you have configured the interfaces correctly:
•Enter the show controller t3 command and specify the slot and port numbers. Verify that the controller is up and that you
do not have excessive errors; otherwise, your controller might go down frequently. This could indicate switch problems.
Gateway# show controller t3 1/0
T3 1/0 is up.
Applique type is Channelized T3
No alarms detected.
MDL transmission is disabled
FEAC code received:No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Internal
Data in current interval (270 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
Total Data (last 32 15 minute intervals):
0 Line Code Violations, 0 P-bit Coding Violation,
0 C-bit Coding Violation, 0 P-bit Err Secs,
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs,
0 Unavailable Secs, 0 Line Errored Secs,
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
•Enter the show controller t1 command and specify the slot and port numbers:
Gateway# show controller t1 1/0
T1 1/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Version info of slot 1: HW:768, PLD Rev:4
Framer Version:0x8
Manufacture Cookie Info:
EEPROM Type 0x0001, EEPROM Version 0x01, Board ID 0x041,
Board Hardware Version 3.0, Item Number 73-4089-03,
Board Revision 05, Serial Number JAB99432626,
PLD/ISP Version 0.1, Manufacture Date 11-Nov-1999.