Cisco Systems Cisco AS5350, Cisco AS5400 - page 24

24
Connecting Serial Port on Cisco AS5400 to CSU/DSU
•Use a coaxial cable to connect a timing signal generator (TSG) to the BITS port. The BITS port is used for external clocking.
Connecting Cisco AS5350 and Cisco AS5400 to BITS Port
•Use a copper wire cable to connect to the alarm port.
Warning The plug-socket combination must be accessible at all times because it serves as the main disconnecting device.
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety
Information document that accompanied this device.
Warning Incorrect connection of this or connected equipment to a general purpose outlet could result in a hazardous
situation. To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance
and Safety Information document that accompanied this device.
30846
Serial
transition
cable
CSU/DSU or
other DCE or DTE
Synchronous serial
port (DB-26)
EIA/TIA-232, EIA/TIA-449, EIA/TIA-530A,
EIA/TIA-530, V.35, or X.21 connector
Internet
35841
BITS port
connector
To timing signal
generator
Coaxial cable