ISDN Switch Types
Area | Keyword | Switch Type |
| | |
Australia | primary-ts014 | Australia PRI switches |
| | |
Europe | primary-net5 | European, New Zealand, and Asia ISDN PRI |
| | switches (covers the Euro-ISDN E-DSS1 |
| | signaling system and is European |
| | Telecommunication Standards Institute or |
| | ETSI-compliant) |
| | |
Japan | primary-ntt | Japanese ISDN PRI switches |
| | |
None | none | No switch defined |
| | |
North America | primary-4ess | AT&T 4ESS switch type for the United States |
| | |
| primary-5ess | AT&T 5ESS switch type for the United States |
| | |
| primary-dms100 | NT DMS-100 switch type for the United States |
| | |
| primary-ni | National ISDN switch type |
| | |
Step 4 Specify the T1 controller you want to configure.
Note The CT1/E1 controller numbering convention is dfc-slot/portin CLI commands. DFC slot numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the motherboard. The DFC slots are numbered sequentially from 1 to 3 for the Cisco AS5350 and 1 to 7 for the Cisco AS5400. Port numbering is from 0 to 7, depending on the trunk DFC installed.
The CT3 controller numbering convention is dfc-slot/portin CLI commands. DFC slot numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the motherboard. The DFC slots are numbered sequentially from 1 to 3 for the Cisco AS5350 and 1 to 7 for the Cisco AS5400. Port number value is always 0. Under the CT3, the CT1 controller numbering convention is dfc-slot/port:channelin CLI commands. Channel values range from 1 to 28. For illustrations showing the slot locations, see the “Slot Numbering” section on page 59
Gateway(config)# controller t1 1/0
or
Gateway(config)# controller t3 7/0:16
or
Specify the E1 controller you want to configure.
Gateway(config)# controller e1 1/0
Note When you configure the CT1or CE1 controller, a corresponding D-channel serial interface is created automatically.
Step 5 Specify the PRI channels:
Gateway(config-controller)# pri-group[timeslots range]
Note For CT1 ISDN PRI—If you do not specify the time slots, the specified controller is configured for 23 B channels and 1 D channel. B channel numbers range from 1 to 23; channel 24 is the D channel for T1. Corresponding serial interface numbers range from 0 to 23. In commands, the D channel is interface serial slot/port:23—for example, interface serial 1/0:23.