Far end camera control in a call only | Cisco Systems CTSMX20042K9

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200

Contents

Getting started

Placing calls

Using directories

In-call features

Settings

User guide

Contact us

Near end camera control				Near end camera presets

Tap More ...	... then tap	Adjust zoom and pan as required.
	Camera Control.	Tap Back to exit.

Far end camera control (in a call only)

This works in point-to-point as well as in multisite calls, but only on systems with remotely controllable cameras.




	Tap the name		... then tap			Adjust zoom and pan as required.
	along the bottom line ...		Camera Control.			Tap Back to exit.

Using Touch Tones (DTMF) in a call

Sometimes you may be urged to enter touch tones (DTMF) during a call, typically to reach extensions or to provide a pin code.

During a call,

or outside a call, tap More ...

... then tap Camera Control.




	...Tap Touch Tones		Use the touch tone keypad.		Tap anywhere outside it to exit.

Tap an existing preset to make the camera move accordingly. To define presets, see “Adding a near end camera preset” on page 6.

D14582.07 User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.	24	www.cisco.com
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.

Image 24

Cisco Systems CTSMX20042K9 manual Near end camera control Near end camera presets, Far end camera control in a call only

Contents

Use with Cisco TelePresence Touch Administrator settings-Call settings Administrator settings-ResetWhat’s in this guide? History Searching Directory Favorites Getting started Basics of the Touch Controller Scroll in listsAs outlined Selfview and camera control Tap Camera control to gainEntering Camera Control will Adding a near end camera preset For the new presetTap More then tap Press Changing an existing near end camera preset Tap Update to current position Removing an existing near end camera preset Tap More Then tap Tap the field to the right Tap Camera Control & Settings to open Camera whitebalance, exposure, and backlight compensationBacklight compensation improves Sound matters Ring tones and soundsDo not disturb Receiving calls Placing calls Calling someone by entering the URI Search or Dial field  Searching and calling an entry in any of the lists Calling an entry in one of the lists Then tap Favorites , Directory , or HistoryEntries, if needed Calling more than one Using Favorites Directory and History History DirectoryFavorites Searching In-call features Features in a call-an overview Layout lets you Change the layout Gain accessOn or off MultiSite only User guide Calling participants to add them to an ongoing call Multiway Features when putting someone on hold Receiving another incoming call Transferring an ongoing call Select whom to transfer to in the usual way Near end camera control Near end camera presets Using Touch Tones Dtmf in a callFar end camera control in a call only Sharing contents-conducting presentations Layout control Speaks gets Shown in frames Full screenMain frame. Identical sizes Nothing else is Shown Settings Settings Gaining access to the Settings Access the Settings as follows System Information Call Status Camera Control & Settings Ringtone & Sound Settings Administrator settings-Date, Time & Location Administrator settings-Call settings Administrator settings-IP settings for the codec Administrator settings-IP settings for the Touch controller Administrator settings-Pairing Administrator settings-H.323 settings An H.323 aliasGatekeeper discovery Manual or Automatic Administrator settings-SIP settings Administrator settings-Provisioning Administrator settings-Multiway Settings Administrator settings-EMC Resilience mode Administrator settings-Reset Contact us