Cisco Systems MGX-FRSM-HS2, MGX-FRSM-2CT3, MGX-FRSM-2T3E3 manual Cnfcdrscprtn 300 300

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Using the CLI to Configure the Card, Lines, and Ports

On the CLI of the AUSM/B:

If necessary, modify the resource partitioning for the whole card by executing the cnfcdrscprtn command. You can view resource partitioning through dspcdrscprtn.

cnfcdrscprtn <number_PAR_conns number_PNNI_conns number_TAG_conns>

•number_PAR_conns is the number of connections in the range 0–1000 for PAR.

•number_PNNI_conns is the number of connections in the range 0–1000 for PNNI.

•number_TAG_conns is the number of connections in the range 0–1000 for MPLS. For example, you could reserve 300 connections for each controller on the AUSM with:

cnfcdrscprtn 300 300 300

Activate a physical line by using addln for each of the eight lines as needed: addln <line_number>

Optionally, use the cnfln command to specify line coding, line length, and clock source: cnfln <line_num> <line_code> <line_len> <clk_src> [E1-signaling]

Execute upport to activate the logical operation of the line: upport <port_number>, where port_number is in the range 1–8. If necessary, execute cnfportq to modify the egress queues:

cnfportq <port_num> <q_num> <q_algo> <q_depth> <clp_high> <clp_low> <efci_thres>

port_num is the logical port number in the range 1–8.

q_num is the queue number in the range 1–16. 0 is the default for addchan.

1=CBR

2=VBR

3=ABR

4=UBR

q_algo is a number to specify the queue algorithm:

0=disable queue

1=high priority—always serve 2=best available

3=minimum guaranteed bandwidth

4=minimum guaranteed bandwidth with maximum rate shaping 5=CBR with smoothing

q_depth is the maximum queue depth in the range 1–16000 cells.

clp_high is the high cell loss priority in the range 1–16000 cells.

clp_low is the low cell loss priority in the range 1–16000 cells.

efci_thres is the EFCI threshold in the range 1–16000 cells.

If necessary, configure resources at the port level by executing cnfportrscprtn. Use dspportrscprtn to see the current resource partitioning.

Card and Service Configuration 6-13