Cisco Systems manual Configuring Cisco MGX 8000 Series Gateways

Chapter 2 Installation

Configuring Cisco MGX 8000 Series Gateways

Note Uninstalling Cisco MGM does not uninstall WanCV and other CiscoView integration files that were installed in Step 2 of the installation procedures. The following directory and files remain in your CiscoView installation:

<CiscoView Root>/www/classpath/ems

<CiscoView Root>/www/classpath/cvpars.properties

<CiscoViewRoot>/www/classpath/com/cisco/nm/cvw/devpkgs/MGX8*.zip

<CiscoView Root>/htdocs/CmgmSessionTimeOut.html

Configuring Cisco MGX 8000 Series Gateways

For the Cisco MGM to communicate with Cisco MGX 8000 Series Carrier Voice Gateways, you must initialize the following parameters for each chassis:

•Management IP address

•Site name

•Read-write community strings

For information about configuring Cisco MGX 8230 nodes, refer to the Cisco MGX 8230 Command Line Interface Guide. For information about configuring Cisco MGX 8250 nodes, refer to the Cisco

MGX 8250 Command Line Interface Guide. For information about configuring Cisco MGX 8850 nodes, refer to the Cisco MGX 8850 Command Line Interface Guide.

For detailed information about managing Cisco MGX 8000 Series gateways using CiscoView, refer to CiscoView Documents on CCO, or refer to the following individual documents:

WAN CiscoView Release 3 for the MGX 8230

WAN CiscoView Release 3 for the MGX 8250

WAN CiscoView Release 3 for Release 1 of the MGX 8850

WAN CiscoView Release 3 for Release 2 of the MGX 8850

Cisco Media Gateway Manager User Guide

78-11705-02 2-11