Cisco Systems OL-6415-04 manual Regulatory Domains

Chapter 2 Configuring Radio Settings

Configuring Radio Channel Settings

Beginning in privileged EXEC mode, follow these steps to set the wireless device’s radio channel:

	Command	Purpose
Step 1
	configure terminal	Enter global configuration mode.
Step 2
	interface dot11radio {0 1 }	Enter interface configuration mode for the radio interface. The
		2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
Step 3
	channel	Set the default channel for the wireless device radio. Table 2-3
	frequency least-congested	through Table 2-6show the available channels and frequencies for
		all radios. To search for the least-congested channel on startup,
		enter least-congested.
		Note The channel command is disabled for 5-GHz radios that
		comply with European Union regulations on dynamic
		frequency selection (DFS). See the “DFS Automatically
		Enabled on Some 5-GHz Radio Channels” section on
		page 2-19for more information.
Step 4
	end	Return to privileged EXEC mode.
Step 5
	copy running-config	(Optional) Save your entries in the configuration file.
	startup-config

Table 2-3shows the available channels and frequencies for the IEEE 802.11b 2.4-GHz radio.

Table 2-3 Channels and Frequencies for 802.11b 2.4 GHz Radio

			Regulatory Domains
Channel	Center
		Americas	China	EMEA	Japan
Identifier	Frequency (MHz)	(–A)	(–C)	(–E)	(–J)
1	2412	X	X	X	X
2	2417	X	X	X	X
3	2422	X	X	X	X
4	2427	X	X	X	X
5	2432	X	X	X	X
6	2437	X	X	X	X
7	2442	X	X	X	X
8	2447	X	X	X	X
9	2452	X	X	X	X
10	2457	X	X	X	X
11	2462	X	X	X	X
12	2467	–	–	X	X
13	2472	–	–	X	X
14	2484	–	–	–	–

Cisco Wireless ISR and HWIC Access Point Configuration Guide

OL-6415-04 2-15