Chapter 2 Configuring Radio Settings

Configuring Radio Channel Settings

 

Command

Purpose

Step 3

 

 

power client

Set the maximum power level allowed on client devices that

 

These options are available for

associate to the wireless device.

 

 

 

802.11b, 2.4-GHz clients (in mW):

Note The settings allowed in your regulatory domain might

 

{ 1 5 20 30 50 100 maximum}

differ from the settings listed here.

 

 

 

These options are available for

 

 

802.11g, 2.4-GHz clients (in mW):

 

 

{ 1 5 10 20 30 50 100

 

 

maximum}

 

 

These options are available for 5-GHz

 

 

clients (in mW):

 

 

{ 5 10 20 40 maximum }

 

Step 4

 

 

end

Return to privileged EXEC mode.

Step 5

 

 

copy running-config startup-config

(Optional) Save your entries in the configuration file.

 

 

 

Use the no form of the client power command to disable the maximum power level for associated clients.

Note Access Point extensions must be enabled to limit the power level on associated client devices. Access Point extensions are enabled by default.

Configuring Radio Channel Settings

The default channel setting for the wireless device radios is least congested; at startup, the wireless device scans for and selects the least-congested channel. For the most consistent performance after a site survey, however, we recommend that you assign a static channel setting for each access point. The channel settings on the wireless device correspond to the frequencies available in your regulatory domain. See the access point’s hardware installation guide for the frequencies allowed in your domain.

Each 2.4-GHz channel covers 22 MHz. The bandwidth for channels 1, 6, and 11 does not overlap, so you can set up multiple access points in the same vicinity without causing interference. Both 802.11b and 802.11g 2.4-GHz radios use the same channels and frequencies.

The 5-GHz radio operates on eight channels from 5180 to 5320 MHz. Each channel covers 20 MHz, and the bandwidth for the channels overlaps slightly. For best performance, use channels that are not adjacent (44 and 46, for example) for radios that are close to each other.

Note Too many access points in the same vicinity creates radio congestion that can reduce throughput. A careful site survey can determine the best placement of access points for maximum radio coverage and throughput.

Cisco Wireless ISR and HWIC Access Point Configuration Guide

2-14

OL-6415-04

 

 

Page 38
Image 38
Cisco Systems OL-6415-04 manual Configuring Radio Channel Settings, Power client, 20 30 50 100 maximum, 10 20 30 50 Maximum