Appendix D Error and Event Messages

802.11 Subsystem Messages

Error Message DOT11-3-RADIO_OVER_TEMPERATURE: Interface [inerface] Radio over temperature detected

Explanation The radio’s internal temperature exceeds maximum limits on the indicated radio interface.

Recommended Action Take steps necessary to reduce the internal temperature. These steps will vary based on your specific installation.

Error Message DOT11-3-RADIO_TEMPERATURE_NORMAL: Interface [interface] radio temperature returned to normal

Explanation The radio’s internal temperature has returned to normal limits on the indicated radio interface.

Recommended Action None.

Error Message DOT11-3-TX_PWR_OUT_OF_RANGE: Interface [interface] Radio transmit power out of range

Explanation The transmitter power level is outside the normal range on the indicated radio interface.

Recommended Action Remove unit from the network and service.

Error Message DOT11-3-RADIO_RF_LO: Interface [interface] Radio cannot lock RF freq

Explanation The radio phase lock loop (PLL) circuit is unable to lock the correct frequency on the indicated interface.

Recommended Action Remove unit from network and service.

Error Message DOT11-3-RADIO_IF_LO: Interface [interface] Radio cannot lock IF freq

Explanation The radio intermediate frequency (IF) PLL is unable to lock the correct frequency on the indicated interface.

Recommended Action Remove unit from network and service.

Error Message DOT11-6-FREQ_SCAN: Interface [interface] Scanning frequencies for [number] seconds

Explanation Starting a scan for a least congested frequency on the interface indicated for a the time period indicated.

Recommended Action None.

Cisco Wireless ISR and HWIC Access Point Configuration Guide

 

D-4

OL-6415-04

 

 

 

Page 160
Image 160
Cisco Systems OL-6415-04 manual Recommended Action None