C H A P T E R 4
Operation, Administration, and Maintenance
This chapter describes the components required for operation, administration, and maintenance of the Cisco ONS 15200.
4.1 Network Control
The Network Control Board (NCB) supervises, administers, and monitors the ONS 15200. In addition to controlling all of the ONS 15200 system Client Layer Interface Port (CLIP) modules, the NCB module collects information about system status, alarms, parameters, and actions on the internal data bus. See the “Alarms” section on page
4.2 Network Management Overview
You can manage an ONS 15200 network using three different connection interfaces:
•An Ethernet connection to the NCB module located in an ONS 15252 Multichannel Unit (MCU).
•A Maintenance Manager software connection over the internal data bus to the Communication Interface Module (CIM) located in an ONS 15252 MCU or to the Collector Control Area Network (CCAN) board located in an ONS 15201
•An Electronic Industries Association/Telecommunication Industry Association (EIA/TIA)
Figure 4-1 illustrates the three network management interface connections.
You can control the ONS 15200 system using the Subnetwork Manager (SNM) software package running on the NCB module located in the ONS 15252 MCU. Access the SNM through either the EIA/TIA-232 port or the Ethernet port on the front of the NCB module. Additionally, you can manage the ONS 15200 system externally using the Command Line Interface (CLI) software package described in the “Command Line Interface” section on page 4-5 or using the Maintenance Manager (MM) software package described in the “Maintenance Manager” section on page 4-6. With the Internet, you can view the ONS 15200 system using the web-based interface described in the “Web-Based Interface” section on page 4-7. In addition, you can use SNMP and the Cisco Transport Manager (CTM) to have read-only access to the ONS 15200.
Cisco ONS 15200 Product Description
|
| ||
|
|
