Cisco Systems PA-POS-1OC3 show interfaces pos 2 or 3 or 4 or, show interfaces pos module-slot

Models: PA-POS-1OC3 PA-POS-2OC3

1 90
Download 90 pages 60.94 Kb
Page 77
Image 77
show interfaces pos 2 or 3 or 4 or 5/

Chapter 4 Configuring the PA-POS-1OC3

Checking the Configuration

Table 4-5

Using show commands (continued)

 

 

 

 

 

Command

 

Function

Example

 

 

 

show interfaces pos 2 or 3 or 4 or 5/

Displays status information about the pos

Router# show interfaces pos 3/0

interface-port-number

interface on a Cisco 7304 PCI Port

 

 

 

Adapter Carrier Card in a Cisco 7304

 

 

 

router

 

 

 

 

show interfaces pos interface-processor-

Displays status information about the pos

Router# show interfaces pos

slot-number/port-adapter-slot-number/

interface on a VIP in a Cisco 7500 series

3/1/0

interface-port-number

router

 

 

 

 

show interfaces pos module-slot-

Displays status information about the pos

Router# show interfaces pos

number/port-adapter-bay-number/

interface on a Cisco 7600 series router

3/0/0

interface-port-number

FlexWAN module

 

 

 

 

show controllers

Displays all the current interface

Router# show controllers

 

 

processors and their interfaces

 

 

 

 

 

show protocols

 

Displays protocols configured for the

Router# show protocols

 

 

entire system and for specific interfaces

 

 

 

 

show running-config

Displays the running configuration file

Router# show running-config

 

 

 

show startup-config

Displays the configuration stored in

Router# show startup-config

 

 

NVRAM

 

 

 

 

 

If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is not functioning properly, ensure that the interface is properly connected and terminated. If you still have problems bringing up the interface, contact a service representative for assistance.

This section includes the following subsections:

Using the show version or show hardware Commands, page 4-14

Using the show diag Command, page 4-17

Using the show interfaces Command, page 4-20

Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify Network Connectivity” section on page 4-22when you have finished using the show commands.

PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide

 

OL-6514-04

4-13

 

 

 

Page 77
Image 77
Cisco Systems PA-POS-1OC3 show interfaces pos 2 or 3 or 4 or, show interfaces pos interface-processor, show controllers