Cisco Systems PA-POS-2OC3, PA-POS-1OC3 manual Platform, Command, Example, shutdown

Chapter 4 Configuring the PA-POS-1OC3

Configuring the Interfaces

Table 4-2 Syntax of the shutdown Command for the Supported Platforms (continued)

Platform	Command	Example
Cisco 7401ASR router	interface, followed by the type (pos) and	The example is for interface 0 on a port adapter
	slot/port (port-adapter-slot-number/	in slot 1.
	interface-port-number)	Router(config-if)# interface pos 1/0
	shutdown	Router(config-if)# shutdown
		Ctrl-Z
		Router#
VIP in the Cisco 7500 series	interface, followed by the type (pos)	The example is for interface 0 in port adapter
routers (7505, 7507, 7513)	slot/port-adapter/port	slot 1 of a VIP installed in interface processor
	(interface-processor-slot-number/	slot 1.
	port-adapter-slot-number/	Router(config)# interface pos 1/1/0
	interface-port-number)
		Router(config-if)# shutdown
		Ctrl-Z
	shutdown	Router#
Cisco 7600 series routers (7603,	interface, followed by the type (pos)	The example is for interface 0 on a port adapter
7606, 7609, 7613) with	module/bay/port	in port adapter bay 0 of a FlexWAN module in
FlexWAN or Enhanced	(module-slot-number/port-adapter-bay-	module slot 3.
FlexWAN	number/interface-port-number)	Router# interfaces pos 3/0/0
	shutdown	Router(config-if)# shutdown
		Ctrl-Z
		Router#

1.For the Cisco 7206VXR router shelves in the Cisco AS5800, the interface specified in the above example would include a shelf number. For example, the command interface serial 5/3/0 specifies the OC-3 interface of the PA-POS-1OC3 in port adapter slot 3 of router shelf 5.

Step 4 Write the new configuration to NVRAM as follows:

Router# copy running-config startup-config [OK]

Router#

The system displays an OK message when the configuration has been stored in NVRAM.

Verify that new interfaces are now in the correct state (shut down) using the show interfaces command (followed by the interface type and interface address of the interface) to display the specific interface.

PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide

4-4 OL-6514-04