Cisco Systems PA-POS-2OC3, PA-POS-1OC3 manual Using the show interfaces Command, 4-20

Chapter 4 Configuring the PA-POS-1OC3

Checking the Configuration

Using the show interfaces Command

Display status information (including the physical slot and interface address) for the interfaces you specifyusing the show interfaces command.

For complete descriptions of interface subcommands and the configuration options available, refer to the publications listed in the “Related Documentation” section on page viii.

Note The ouputs that appear in this document may not match the output you receive when running these commands. The outputs in this document are examples only.

The following sections provide output of the show interfaces command for some of the supported platforms:

•Cisco 7200 VXR Series Routers—Example Output of the show interfaces Command, page 4-20

•Cisco 7201 Router—Example Output of the show interfaces Command, page 4-21

•Cisco 7301 Router—Example Output of the show interfaces Command, page 4-21

•VIP in Cisco 7500 Series Routers—Example Output of the show interfaces Command, page 4-22

Cisco 7200 VXR Series Routers—Example Output of the show interfaces Command

Following is an example of the show interfaces pos command for a PA-POS-1OC3 in port adapter slot

4 of a Cisco 7200 VXR router:

Router# show interfaces pos 4/0 PE3#sh int pos4/1

POS4/1 is down, line protocol is down Hardware is Packet over Sonet Internet address is 142.50.8.3/24

MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255

Encapsulation HDLC, crc 16, loopback not set Keepalive not set

Scramble disabled

Last input never, output never, output hang never Last clearing of "show interface" counters 3d23h

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts (0 IP multicast)

0 runts, 0 giants, 0 throttles

0 parity

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns

0 output errors, 0 applique, 20 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

Note For the Cisco 7206 VXR router shelves in the Cisco AS5800 Universal Access Router, the show interfaces pos command requires a shelf number in the format show interfaces pos shelf-number/port-adapter-slot-number/interface-port. For example, the command show interfaces pos 5/3/0 specifies the OC-3 interface of a PA-POS-1OC3 in port adapter slot 3 of router shelf 5.

PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide

4-20 OL-6514-04